Table of Contents
Advertisement
Do the following steps to load tractored fan-fold forms:
v If you are using fan-fold forms, position the boxed fan-fold forms in the forms
v Thread the forms to the transfer station. See "Threading tractored fan-fold
v Align the forms on the tractor pins. See "Aligning the forms on the tractor pins"
v If you are changing to a different size form on Printer 1, you must change the
v Load the forms. See "Loading forms using the Forms Feed button" on page 99.
v Check forms alignment. See "Checking alignment of tractored forms" on page
v Start the printer. See "Starting the printer" on page 103.
Positioning boxed fan-fold forms in the forms input area
About this task
Do this procedure to load fan-fold forms from the forms input area to the transfer
station.
Procedure:
Procedure
1. Open a box of forms.
2. Put the forms on the floor of the forms input area. The print surface of the
88
Operating the InfoPrint 4100
input area. See "Positioning boxed fan-fold forms in the forms input area."
forms" on page 91.
on page 94.
forms settings (or Snapshot) on Printer 1. See "Changing forms settings on
Printer 1" on page 97.
Note: Do this step when loading forms in Dual Simplex mode or loading Printer
1 in Duplex mode.
Note: If you are using the Auto Load sequence to load the forms, you must set
the forms length at the stacker control panel before starting the Auto Load
sequence. See "Setting the forms length for Auto Load" on page 134 and
"Starting the Auto Load sequence" on page 134.
102.
forms must be toward your right (as you face the printer) as you lift forms
from the stack.
Note: If you plan to leave the forms in the box, do the following:
v Ensure that the box does not interfere with form movement.
Advertisement
Table of Contents
