10. Close the oiler gate.
11. Turn the wing nut clockwise to latch the gate. Ensure that the gate is firmly
12. Close the end cover.
13. The fuser begins a warm-up cycle. Make the printer ready by pressing Start
308
Operating the InfoPrint 4100
5. Allow the oiler belt to cool for at least 10 minutes.
6. Lower the hot roll shield.
7. Spread papers on the floor or place a wastebasket under the oiler belt.
8. Use a piece of lightweight cardboard to scrape paper dust and paper chads
from the oiler belt.
9. Raise the hot roll shield.
latched.
on the printer operator panel or the Main touch panel of the affected printer.