Ricoh InfoPrint 4100 TS2 Operating Manual page 357

d. Install the corona cartridge into the front wire holder on the corona
assembly as follows:
1) Carefully thread the wire into the slit in the mylar piece (1) at the front
end of the corona assembly. The wire must pass through the slit before
the cartridge can be snapped into place.
1
2) Tilt the cartridge (1) to position it so that the groove (4) slides under
the pin (5) on the front wire holder.
3) Push the cartridge down until the flexible latch on the cartridge (2)
snaps into place in the front wire holder (3).
2
3
e. Close the corona wire cover (1) by pushing it in the A direction.
1
4
5
Chapter 7. Cleaning and Servicing the printer
343