Table of Contents
Advertisement
1
E
1
6. Gently push the corona assembly back into place inside the corona housing.
Make sure that the corona assembly is pushed in completely.
Note: The labels on the end of each corona assembly correspond to the labels
outside the drum. These indicate the correct location for each corona assembly.
When replacing corona wires, make sure that the correct corona assembly is
installed in the corresponding corona housing.
7. Do the following to remove the precharge and preclean corona wires. Do these
steps for each corona assembly, one at a time.
a. Pull the corona assembly out of the corona housing.
F
Chapter 7. Cleaning and Servicing the printer
331
Advertisement
Table of Contents
