Ricoh InfoPrint 4100 TS2 Operating Manual page 232

218
Operating the InfoPrint 4100
Table 13. Operator message codes (continued)
Code Description
0131 Tension arm down
0132 Tension arm up
0133 Skew error
0134 Fuser wrap
0184 Transfer station forms jam (Auto
Load)
0185 Upper fuser forms jam (Auto Load)
018C Toner mark not sensed
018D Registration mark not sensed
018E The Mark Sensor is not Ready
0191 Upper tractor forms jam (Auto Load) See "Clearing forms jams" on page 230.
0196 Splice lever down (Auto Load)
0198 End-of-forms (Auto Load)
Reference
v See "Checking the tension arm" on
page 147.
v See "Clearing forms jams" on page
230.
See "Clearing forms jams" on page 230.
v Check to see if the verification mark
was printed correctly.
v See "Aligning tractored forms" on
page 155.
v See "Aligning tractorless forms" on
page 163.
v Check to see if the verification mark
was printed correctly.
v See "Aligning tractored forms" on
page 155.
v See "Aligning tractorless forms" on
page 163.
v Rotate the upper mark sensor
assembly down to the closed position.
v If the upper mark sensor assembly is
in the closed position, do the
following:
1. Shut down the system.
2. Power off the system.
3. Power on and retry the operation.
If this does not fix the problem, call for
service.
See "Splicing tractored forms" on page
150.
v Splice or load new forms.
v See "Splicing tractored forms" on page
150.
v See "Loading forms" on page 69.