Table of Contents
Advertisement
Service panel
Diagnostics - Testing and adjusting the Universal Forms Control
(UFC) sensor
Service and administrators use the Diagnostics - Adjusting the universal forms
control module to run diagnostic tests to identify problems with the Universal
Forms Control (UFC) sensor. Instructions are displayed about how to execute the
selected test.
Select Maintenance → Adjustments & Diagnostics → Adjust Mark Sensor to
display this panel.
Note: The printer must be stopped before this function can be performed.
Note: To see help information for the fields on this panel, select the field and press
F1 on the keyboard or press and hold the left mouse button for two seconds. A
help popup window displays detailed information about the selected field. Select
the Help button to display a help topic for the panel. The help topic displays in a
separate Help window inside a Help System viewer. Select the Alt+Tab key to
toggle between the Help window and the operator console. Select the Alt+F4 key
to close the Help window.
Administrator panel
Related tasks
"Adjusting the Universal Forms Control (UFC) sensor in look down mode" on
page 199
Follow these steps to set the UFC sensor to read registration or side verify marks
from above the forms. This function is only available in Administrator or Service
mode.
"Adjusting the Universal Forms Control (UFC) sensor in look up mode" on page
203
Follow these steps to set the UFC sensor to read registration or side verify marks
from below the forms (same side printing only). This function is only available in
Administrator or Service mode.
"Selecting the Universal Forms Control (UFC) sensors" on page 198
Use these instructions to select which UFC sensor you want to adjust. Choosing
the lower mark sensor reads the front of the forms; choosing the upper mark
sensor reads the back of the forms. This function is only available in Administrator
or Service mode.
Initializing the Universal Forms Control (UFC) sensor function
The initial setting of the Universal Forms Control (UFC) sensor function is done
during installation by the customer support specialist and is not changed by
powering off the printer. This function is only available in Administrator or Service
mode.
Related information:
371
Chapter 8. Help topics for the InfoPrint 4100 operator console
Advertisement
Table of Contents
