Table of Contents
Advertisement
FORMS WIDTH
19
18
17
16
FORMS LENGTH
7
8
9
10
11
1/2
2/3
0
1/3
8
Figure 20. Stacker control panel on InfoPrint 4100 models
Selecting This Control:
FORMS WIDTH
FORMS LENGTH
15
14
13
12
11
TABLE
12
13
14
READY
UP
TABLE
STOP
STOP
DOWN
Does This:
This control is not active on InfoPrint 4100 Models TS3
and TD5/6.
On InfoPrint 4100 with the stacker installed, this control
increases or decreases the stacker forms width setting.
The FORMS WIDTH lever should be set to the position
that corresponds to the forms width shown on the
stacker LED display (14.0 in the above illustrations).
Displays the current forms length and lets you adjust it.
On InfoPrint 4100 with the stacker installed, this control
increases or decreases the stacker forms length setting.
Figure 20 shows a forms length setting of 8 2/3. To use
the stacker, set the FORMS LENGTH on the stacker
control panel between 7 and 14, or 7 and 17 inches.
Note: If you are not using the stacker, you must still set
the forms length to allow Auto Load to function
correctly.
Chapter 1. Introducing the printer
27
Advertisement
Table of Contents
