Table of Contents
Advertisement
You will do the following steps to load tractorless roll-feed forms:
v Thread the forms to the transfer station. See "Threading tractorless forms."
v Adjust the tractorless feeding unit. See "Adjusting the tractorless feeding unit"
on page 119.
v If you are changing to a different size form on Printer 1, you must change the
forms settings (or Snapshot) on Printer 1. See "Changing forms settings on
Printer 1" on page 110.
Note: Do this step when loading forms in Dual Simplex mode or loading Printer
1 in Duplex mode.
v Load the forms. See "Loading forms using the Forms Feed button" on page 112.
Note: If you are using the Auto Load sequence to load the forms, you must set
the forms length at the stacker control panel before starting the Auto Load
sequence. See "Setting the forms length for Auto Load" on page 134 and
"Starting the Auto Load sequence" on page 134.
v Start the printer. See "Starting the printer" on page 115.
Threading tractorless forms
About this task
Do this procedure to thread tractorless forms from the forms input area to the
transfer station.
Procedure:
Procedure
1. Ensure that the transfer station is closed and latched.
2. If you are loading a form with a different width, use the Tractor Control Knob
to adjust the tractors close to the correct width. Use the scale just to the left of
the tractor covers.
Chapter 5. Working with forms
105
Advertisement
Table of Contents
