Table of Contents
Advertisement
10. Select Start on the printer operator panel or on the Main touch panel to begin
Aligning forms with no forms in Printer 2
Before you begin
This procedure assume that:
v The form position is set properly based on its paper size on Printer 1 before
v You have visually checked the entire forms path and have found that the forms
v All interventions are cleared. If interventions exist, you may have to manually
About this task
Procedure:
158
Operating the InfoPrint 4100
Note: When forms are longer than 14" in size, the printer prints a dashed line
with 14" next to it. Line this mark up with the 14" mark on the ruler in Printer
2. Otherwise, the alignment line would not reach the ruler.
a. If the Printer 1 alignment mark is short of the appropriate forms length
scale mark in Printer 2, select the appropriate paper advance (feed page)
key on the Align Forms panel or on the printer operator panel, pressing as
many times as necessary until the Printer 1 alignment mark is aligned at
Printer 2.
b. If the Printer 1 alignment mark is past the forms length scale mark in
printer 2, add some more buffer loop between Printer 1 and the
Buffer/Flipper Unit. Select the appropriate paper advance (feed page) key
several times. Then select Cancel on the panel. You must now perform this
Align Forms procedure again.
7. After you have visually verified that the Printer 1 alignment mark is aligned
correctly on Printer 2, select OK at the verification panel. This informs the
control unit that the alignment is complete.
8. If a postprocessing device is installed and not threaded, select Advance Paper
(NPRO) to advance enough forms to thread the postprocessing device.
9. Select Close to close the panel.
printing.
beginning this procedure or the resulting print will not be aligned at the top of
the form.
are not separated.
re-thread the forms and then select Check Reset until all interventions are
cleared and remain cleared.
Advertisement
Table of Contents
