Table of Contents
Advertisement
On all printer models, the stacker control panel contains controls for setting the
form length.
3
Figure 17. Forms exit area
On InfoPrint 4100 models with a stacker installed, the printed and fused forms
leave the fuser area and are refolded in the stacker area. The pendulum is inside
the stacker area, above the stacker table. The swinging of the pendulum helps
forms to refold correctly. The stacker control panel, which is just above the stacker,
contains controls for setting the form width, the form length, and the stacker table
position.
Attention: Printing to the internal stacker is not supported in duplex mode.
24
Operating the InfoPrint 4100
1
2
Advertisement
Table of Contents
