6. Check the position of the form suspended between the tractors. If the middle of
Feed Hole
Tractor Pin
7. Close the lower tractor covers.
8. Adjust the rear paper-edge guide as follows:
96
Operating the InfoPrint 4100
the form is slack, the tractors are too close together.
Note: This step applies to InfoPrint Models TS2, and TD3/4 when the Dual
Toner Mark/Side Verify Sensor feature (FC 4570) is installed.
a. Loosen the thumbscrew (2).
b. Slide the rear paper-edge guide (1) to the correct location for the current
paper width. The paper should be positioned against the vertical surface of
the guide (3) so that the sensor on the bottom side of the sensor mounting
plate can read side verify marks and registration marks, which are printed
on the outside edge of the paper. The edge guide is also used to guide the
paper in tractorless mode.