Table of Contents
Advertisement
Auto Load
Forms Set
Load
STOP
Figure 51. Auto Load - Load key on the printer control panel
2. Ensure that the tension arm is aligned correctly. The mark on the tension arm
1
3. At the transfer station, ensure that the perforation is aligned with the correct
Toner
Mark
Forms Feed
Forward
Reverse
The automatic loading process does the following:
v Raises the auto load bridge.
v Lowers the tension arm.
v Passes the forms through the transfer station, across the tension arm and
bridge, and into the fuser entry area.
v Moves the forms into the forms exit area.
After a slight pause, the automatic loading process does the following:
v Adjusts the tension-arm position.
v Lowers the auto load bridge.
Note: If a forms jam occurs during the Auto Load sequence, see "Clearing
forms jams" on page 230.
(1) should be visible in the notch in the transfer station frame. See "Checking
the tension arm" on page 147.
forms length (the forms length set at the stacker control panel). For example,
forms that are 11 inches long should be aligned so that the perforation is at the
11-inch mark. The forms length must be set as follows:
v For forms that are 7 inches or greater - set the forms length to the actual
length of the form.
v For forms that are 3-1/2 to 6-2/3 inches - set the forms length to two times
the actual length of the form.
Chapter 5. Working with forms
135
Advertisement
Table of Contents
