Ricoh InfoPrint 4100 TS2 Operating Manual page 234

220
Operating the InfoPrint 4100
Table 13. Operator message codes (continued)
Code Description
0794 Oiler gate open
0795 Set forms direction
0799 Check fine filter
079A Check Tension Arm
079D Oil supply low
079E Developer mismatch
07D1 Developer interface error
07D2 Developer interlock switch open
07D3 Tractor initial position error
07D4 The premeasure gate is open
07D7 Toner Collector is full or not
installed correctly
Reference
v Ensure that the oiler gate is closed.
v See "Cleaning the oiler belt" on page
306.
See "About the printer control panel" on
page 13.
See "Checking the fine filter" on page
299.
See "Checking the tension arm" on page
147.
v Add one or two bottles of oil. See
"Adding fuser oil" on page 279.
v After adding oil, select the appropriate
button on the intervention message
window to indicate the number of
bottles of oil you added.
The customer-changeable developer
installed in the printer is not the correct
toner type. Make sure the correct
customer-changeable developer is
installed in the printer.
1. Make sure the correct
customer-changeable developer is
installed in the printer.
2. Select OK to close the message
window and retry the operation.
If the problem continues, call for service.
Ensure the developer communication
cable is plugged in correctly.
Ensure that the developer is seated
properly and that the gate is shut.
Verify proper position of tractors and
correct if necessary.
1. Ensure that the forms are threaded
correctly.
2. Close the premeasure gate.
3. Select Check Reset.
If the problem continues, call for service.
1. Ensure that toner collector is not full
2. Ensure that the toner collector is
properly positioned.
3. See "Checking the toner collector" on
page 282.