Table of Contents
Advertisement
v You should clean the printer only with a vacuum cleaner that is approved for
v You need the following items to clean the printer:
Procedure:
Perform this procedure to clean the printer.
Procedure
1. Disable the protocol.
2. Separate the forms at a perforation near the splicing table.
3. Raise the static brush at the splicing table so that the forms fall back into the
4. Advance the forms by doing one of the following:
5. Select Advance Paper (NPRO) or press NPRO again. In Duplex mode, the
6. Unload the stacker.
7. Perform the " Shutdown" procedure.
8. Switch off power to the printer.
9. Plug a toner-certified vacuum cleaner into an ac outlet near the printer.
256
Operating the InfoPrint 4100
toner applications.
– Toner-certified vacuum cleaner
Ensure that the vacuum cleaner used to clean the printer meets the following
requirements:
- All attachments or tools that are connected to the vacuum cleaner through
which paper dust, toner, or developer mix pass are non-conductive.
- Vacuum-cleaner motor cooling must be separate from the vacuum line so
that these same substances do not contact the electrical brushes of the
vacuum-cleaner motor. Filtering the vacuum line and allowing the filtered
air to cool the motor is not safe.
– Cloth or paper towels
– Cotton swabs
– Long-handled nylon bristle brush (P/N 451555)
input area. Ensure that the end-of-forms sensor is not covered by forms in the
input area.
v On the touch panel, select Advance Paper (NPRO).
v On the operator panel, press NPRO.
v Manually advance the paper.
The 078A END OF FORMS message appears on the touch panel.
Note: NPRO does not operate if the forms have not been aligned.
forms move through both Printer 1 and Printer 2 to a postprocessing device
behind Printer 2. In Dual Simplex mode, the forms move through the printer to
the stacker or to a postprocessing device behind the printer.
If the forms have moved to a postprocessing device, switch off power to the
printer. If the forms have moved to a printer stacker, unload the stacker and do
the "Shutdown" procedure.
Attention: Damage to the printer can occur if printer power is not turned off
before you use the vacuum cleaner.
Related information:
"Cleaning the oiler belt" on page 306
"Enabling and disabling protocols" on page 52
Advertisement
Table of Contents
