Table of Contents
Advertisement
Setting the forms length for Auto Load
About this task
Do this procedure to set the forms length at the stacker control panel. The forms
length value is used when doing the Auto Load sequence.
Procedure:
Procedure
1. If you are loading forms that are the same as the forms that were last used on
2. For the Auto Load sequence to execute properly, you must set the forms length
Starting the Auto Load sequence
About this task
Do this procedure to start the Auto Load sequence.
Note: This procedure is for tractored forms. If you are loading tractorless forms
and the damper kit is installed, Auto Load controls will not be available on the
printer control panel. You must load the forms using the manual load procedure
(see "Loading forms using the Forms Feed button" on page 82 for instructions).
Procedure:
Procedure
1. Press the Auto Load - Load key on the printer control panel to start the
134
Operating the InfoPrint 4100
forms on Printer 2. Depending on the type of form you are loading, refer to
"Aligning tractored forms" on page 155 or "Aligning tractorless forms" on page
163.
the printer, no action is required. Go to "Starting the Auto Load sequence."
Otherwise, continue to the next step.
on the stacker control panel to match the folding length of the forms you are
loading.
a. Set the FORMS LENGTH as follows:
v For forms that are 7 inches or greater - set the forms length to the actual
length of the form.
v For forms that are 3-1/2 to 6-2/3 inches - set the forms length to two
times the actual length of the form.
v For forms that are 3 or 3-1/3 inches - set the forms length to three times
the length of the actual form (at the perforation to perforation distance)
as it is folded before printing.
b. Press the FORMS LENGTH key to increase or decrease the form length
(see "About the stacker control panel" on page 25).
Note: The forms length value entered here is the form length as measured
from fold perforation to fold perforation before printing. For example, if a form
has page perforations that are 3-1/2 inches apart and fold perforations that
are 7 inches apart, use 7 as the stacker form-length value. Refer to "Valid
Forms Lengths in Inches" in the Planning and Configuration Guide for help in
deciding the correct length to specify at the stacker control panel.
automatic loading process.
Advertisement
Table of Contents
