Table of Contents
Advertisement
About this task
Do this procedure to install the preheat platen PTFE mat and wear strip.
Procedure:
Procedure
1. Shut down and power off the system.
2. Remove all forms from Printer 2.
3. Open the center and top covers of the printer.
4. Open the back cover, the stacker gate and stacker door, and the oiler gate to
allow the air flow to help cool down the preheat platen.
5. Attach the PTFE mat and wear strip to the clip as follows:
a. Lay the wear strip (4) and mat (6) on a flat surface with the sensor cutouts
(5) as shown. Lay the clip (3) on top of the mat and wear strip so that the
lip (1) faces up.
b. Insert the clip through the slots in the mat and wear strip as shown. To
make the installation easier, use cellophane tape (2) to attach the mat and
wear strip to the clip.
427
Appendix. Features
Advertisement
Table of Contents
