Table of Contents
Advertisement
Table 13. Operator message codes (continued)
Code
Description
07D8
Incorrect Retractor Gap Position -
Tractorless Enhanced Commercial
Print
07D9
Incorrect Retractor Gap Position
07DA
Lift Pin Position Error
07DB
Lift Pin Position Error
07DC
Lift Pin Position Error
D204
Pre/postprocessor NOT READY line
became active.
D21F
Page too complex
Reference
The Transfer Station Gap Lever is not in
the expected position.
1. Move the Transfer Station Gap Lever
to the bottom position.
2. Select Start to continue printing.
3. Call for service if the problem
continues.
The Transfer Station Gap Lever is not in
the expected position.
1. Move the Transfer Station Gap Lever
to the top position.
2. Select Start to continue printing.
3. Call for service if the problem
continues.
The lift pins are not in the expected
position.
1. Move the Lift Pin Lever to the 3 mm
position.
2. Select Start to continue printing.
3. Call for service if the problem
continues.
Forms → Form Settings → Commercial
Print is set to Yes, but the lift pins are
not in the expected position.
1. If using 9pt forms, move the Lift Pin
Lever to the 10 mm position.
2. If 9pt forms are not loaded, set
Forms → Form Settings →
Commercial Print to No.
3. Select Start to continue printing.
4. Call for service if the problem
continues.
The lift pins are not in the expected
position.
1. If 9pt forms are not loaded, move the
Lift Pin Lever to the 3mm position.
2. If using 9pt forms, set Forms → Form
Settings → Commercial Print to Yes
and move the Lift Pin Lever to the 10
mm position.
3. Select Start to continue printing.
4. Call for service if the problem
continues.
See "Clearing a forms jam in a
postprocessing device" on page 239 or
"Clearing a forms jam between the
printer and a postprocessing device" on
page 238.
Page needs to be redesigned.
Chapter 6. Taking care of problems
221
Advertisement
Table of Contents
