Table of Contents
Advertisement
Procedure
CAUTION:
<70> The oiler belt, oiler wick roll, and their environments are
high-temperature
these areas.
Stacker Table
10. If forms remain in the fuser, do the following:
242
Operating the InfoPrint 4100
1. Open the stacker gate.
2. Break the forms at a perforation near the forms guide.
3. Break the forms at a perforation near the pendulum.
4. Unload the forms from the stacker.
5. Close the stacker gate.
6. Press the Vacuum push button. The Vacuum-Off Warning Indicator flashes
and then stays lit.
7. Move the puller lever to the left.
8. Grasp the forms near the fuser entry area and pull them up and out of the
fuser. (This moves the forms in the opposite direction from their usual path.)
9. If the forms will not pull up, or if some forms remain in the pendulum, do the
following:
a. Lower the stacker table.
b. Open the stacker gate.
c. Grasp both sides of the forms and pull down evenly.
d. Close the stacker gate.
e. Raise the stacker table.
areas. Be very careful when working in
Advertisement
Table of Contents
