Table of Contents
Advertisement
Select a beam number to indicate which beam(s) the changes will affect. Use the
Alternate test sample to determine the offset value to use in order to align the
beam start position with Beam 1. Do this by adding the offset value on the sample
that shows the best alignment for each beam to the start position of Beam 1 to
determine the offset value to enter for each beam offset. For example, look at the
Alternate test sample. If the registration for Beam 2 on Printer 1 was aligned
correctly with Beam 1 at the value of -1, you would enter a value of 7 for Beam 2
Offset for Printer 1, which was using the default starting position of 8.0 for Beam
1. You would then continue to enter values for the other beams based on the
alternate test master.
Note: The printer must be stopped before this function can be performed.
Note: To see help information for the fields on this panel, select the field and press
F1 on the keyboard or press and hold the left mouse button for two seconds. A
help popup window displays detailed information about the selected field. Select
the Help button to display a help topic for the panel. The help topic displays in a
separate Help window inside a Help System viewer. Select the Alt+Tab key to
toggle between the Help window and the operator console. Select the Alt+F4 key
to close the Help window.
Service panel
Print Quality Enhancement window (Service only)
Use the Print Quality Enhancement window to make adjustments to enhance print
quality. You can change Boldness and Stroke Width values for each beam and
vector.
Note: Selecting All in the Beam field changes all the values for each beam to
match those currently displayed, taking the place of any changes you have already
made for other beams.
Select Printer Definition → Print Quality → PQE Adj... to display this panel.
Select Vector Contents to adjust the vector values. You can modify the sixteenth
byte on the horizontal and vertical vectors.
Select OK to save changes you have made. A confirmation window displays. Select
OK to keep the changes and return to the Print Quality panel or select Cancel to
return to the Print Quality Enhancement window.
Note: The printer must be stopped before this function can be performed.
The Print Test option allows you to print test pages that show the changes you
have made. If you select Alternate Master, you can specify the number of test
pages you want to print with the currently displayed PQE values. If you select
Boldness Extremes, the printer prints three test pages, one with a Boldness value
of 100, one with a Boldness value of 0, and a blank page with the values that are
currently displayed on the panel.
375
Chapter 8. Help topics for the InfoPrint 4100 operator console
Advertisement
Table of Contents
