Table of Contents
Advertisement
Select one of the following alignment procedures to load forms in duplex mode or
when you receive an error in the Operator Messages area of the Main touch panel:
v "Aligning forms in both printers"
v "Aligning forms with no forms in Printer 2" on page 158
v "Aligning forms when forms are broken between printers" on page 160
Aligning forms in both printers
Before you begin
This procedure assumes that:
v The form position is set properly based on its paper size on Printer 1 before
v You have visually checked the entire forms path and have found that the forms
v All interventions are cleared. If interventions exist, you may have to manually
About this task
Do this procedure to align forms that are loaded through both printers in a duplex
system.
Procedure:
Procedure
156
Operating the InfoPrint 4100
tractored forms" on page 195 and the "Printer Configuration Items" table in the
Planning and Configuration Guide for more information
beginning this procedure or the resulting print will not be aligned at the top of
the form.
are not separated.
re-thread the forms and then select Check Reset until all interventions are
cleared and remain cleared.
1. Select Forms → Align Forms to display the Align Forms panel.
Advertisement
Table of Contents
