Table of Contents
Advertisement
17. Gently push the transfer corona assembly (3) back into place. Make sure that
18. Close the transfer station by gently pushing the transfer station toward the
19. Close the printer center front cover (1).
344
Operating the InfoPrint 4100
A
1
the corona assembly is pushed in completely.
Note: The labels on the end of each corona assembly correspond to the labels
outside the drum. These indicate the correct location for each corona assembly.
When replacing corona wires, make sure that the correct corona assembly is
installed in the corresponding corona housing.
photoconductive drum and latch it in place, using the transfer station control
lever (2).
Advertisement
Table of Contents
