Table of Contents
Advertisement
1
6
2
5
4
3
Figure 18. Forms exit area with stacker
1. Stacker control panel
2. End cover
3. Forms exit area
4. Stacker table
5. Pendulum
6. Finger belts
7. Stacker gate (open)
About the stacker control panel
The FORMS LENGTH control on the stacker control panel displays the current
form length and lets you adjust it. The following illustration shows a forms length
setting of 8 2/3.
Note: When a stacker is not installed, you must still set the forms length to allow
the Auto Load sequence to function properly.
25
Chapter 1. Introducing the printer
Advertisement
Table of Contents
