Table of Contents
Advertisement
What to do next
If you are using the Auto Load sequence to load the forms, you must set the forms
length at the stacker control panel. See "Setting the forms length for Auto Load"
on page 134. If you are loading the forms manually, see "Loading forms using the
Forms Feed button."
Loading forms using the Forms Feed button
Before you begin
Hold the tension arm so that it stays aligned with the blue mark on the guide
notch while you do the following steps. Otherwise, the 079A CHECK TENSION ARM
079A message appears when you turn on the forms path vacuum, and you must do
the Check Tension Arm procedure.
About this task
Do this procedure to manually load the forms using the Forms Feed button on the
printer control panel.
Procedure:
Procedure
82
Operating the InfoPrint 4100
Note: If the Snapshot is not defined, see Chapter 4, "Working with Snapshots,"
on page 61 for more information about defining Snapshots.
1. Open all paper guides, tractor units, and feeding units to their widest position
in both Printer 1 and Printer 2:
v Use the Tractor Control Knob (6) to adjust the tractors to the widest
possible width. Use the scale just to the left of the tractor covers.
v Adjust the tractorless feeding unit (drive roller, pressure roller, and vacuum
belt unit slots (1)) to the widest position.
v Adjust all tractor units to the outermost position. To adjust a unit, press the
blue button (5) while grasping the unit and slide the unit to the outermost
position.
Note: Make sure the tractor slot (2) is in the Tractorless Feed mode (3).
Position (4) is Tractor Feed mode.
Advertisement
Table of Contents
