Table of Contents
Advertisement
Note: Channel adapters do not require a logical install as they will automatically
display on this panel after the adapter card is physically installed. Once physically
installed, the channel protocol will appear in the "Channels" section. You can then
logically install or uninstall the protocol.
A protocol is a method that the printer uses to receive data, such as IPDS TCP.
When an adapter is logically installed, the protocols for the adapter are available
for installation and can be installed using this panel. Initially, none of the protocols
for an adapter are installed after the adapter is logically installed.
Select Printer Definition → Network → Attachments to display this panel.
To install an ethernet adapter, select the adapter from the list and select Install to
display a configuration window. This window allows you to set configuration
values for the selected adapter.
To install a protocol, select the protocol from the list and select Install to display a
configuration window. This window allows you to set configuration values for the
protocol.
Select Edit... to modify the configuration values for the selected adapter or
protocol. Select Uninstall... to uninstall the selected LAN adapter or protocol. A
protocol must be disabled before it can be uninstalled. In general, for the IPDS
protocols, (channel and IPDS-TCP), changes to values take effect the next time the
protocol is enabled. For non-IPDS protocols, changes to values take effect at the
next job boundary.
Note: Channel adapters cannot be logically uninstalled.
Select Enable or Disable to enable or disable the selected adapter or protocol.
Note: To see help information for the fields on this panel, select the field and press
F1 on the keyboard or press and hold the left mouse button for two seconds. A
help popup window displays detailed information about the selected field. Select
the Help button to display a help topic for the panel. The help topic displays in a
separate Help window inside a Help System viewer. Select the Alt+Tab key to
toggle between the Help window and the operator console. Select the Alt+F4 key
to close the Help window.
Administrator panel
Network - Adapters window
Use the Network - Adapters window to change configuration values for ethernet
adapters.
The following applies to the configuration settings for an ethernet adapter:
Primary
382
Operating the InfoPrint 4100
Multiple LAN Adapters may be logically installed. Only one LAN adapter
may be marked as primary adapter. The following fields only apply to the
adapter that is marked as primary, and therefore only appear on the
adapter panel that is marked as primary:
Advertisement
Table of Contents
