Table of Contents
Advertisement
3
2
5
3. Open the gate by pushing in (4) and pulling up and out on (5).
4. Engage the tractorless pressure roller (6) by moving it into the down position.
5. Turn off the forms path vacuum by pressing the Vacuum Push Button in the
6. Use the Forms Feed keys on the printer control panel to feed the forms over
Auto Load
Forms Set
Load
STOP
Figure 43. Forms Feed button
6
4
forms input area. The Vacuum-Off warning indicator flashes and then stays lit.
the tension arm and into the preheat platen area, guiding them with your other
hand. Keep feeding the forms until the scuff rollers grab them and feeds them
into the forms exit area. Continue feeding the forms until there is enough
length to allow you to splice the forms before feeding them into the post
processor, or until there is enough length to reach the post processor.
Toner
Mark
Forms Feed
Forward
Reverse
1
Chapter 5. Working with forms
101
Advertisement
Table of Contents
