Table of Contents
Advertisement
About this task
Do this procedure to use the Signature Page feature, which allows you to use
forms up to 54 inches long. This longer form size requires a receptacle (a tub) to
hold the forms when they exit Printer 1. If a forms jam occurs in Printer 1, it stops
printing immediately. However, Printer 2 continues to advance the forms to the top
of the next page, using the forms that have collected in the tub.
The tub should be placed in the print path between the forms exit area of Printer 1
and the Buffer/Flipper Unit. Ensure that the tub is in place before you begin the
threading procedure. Once the tub is in the correct position, you can lower the foot
pads to prevent the tub from accidentally moving. (For dual Simplex printing, the
tub must be moved out of the print path. Raise the foot pads to move the tub.)
After you thread Printer 1, thread the forms over the top roller on the tub and
between the tub and the side roller. Leave enough slack in the forms in the tub.
Thread the Buffer/Flipper Unit as you would normally thread it.
Figure 115. Paper path using the Signature Page feature
1. Flipper
2. Fuser
3. Input forms area
When you are using signature page forms and printing has stopped, whether
because of a jam or a need for new supplies such as toner or forms, the print job
restarts at the defined recovery point when you press Start.
Procedure:
Procedure
1. Select Printer Definition → Printer → Setup to display the Printer - Setup panel.
2. Add 54 to the value the Printer 1 to Printer 2 Distance field and type that new
410
Operating the InfoPrint 4100
value in the field.
Advertisement
Table of Contents
