Ricoh InfoPrint 4100 TS2 Operating Manual page 88

Figure 38. Forms input area with splicing
table
3. When threading roll-feed forms, thread the forms from the roll feeder to the
4
6
4. Thread the forms from the forms input area and up to the Universal Forms
74
Operating the InfoPrint 4100
forms input area, as follows:
a. Thread the forms under the lower roller (1) and between the bar (2) and the
machine frame (3).
b. Raise the pressure rollers (4) and thread the forms over the urge unit driver
roll (5). Leave the pressure rollers (4) open.
c. Thread the forms under the flap (6) and into the forms input area.
d. Lower the pressure rollers (4).
5
3
2
1
Control (UFC) sensor or splicing table (if installed), as follows:
a. Open the tension gate (2).
b. Thread the forms through the tension bars and rollers (1), leaving the
tension gate (2) and roller open.
Figure 39. Forms input area with Universal
Forms Control