Ricoh InfoPrint 4100 TS2 Operating Manual page 166

1
2
Figure 57. Splicing table
152
Operating the InfoPrint 4100
5
6
8. Move the rear paper-edge guide (2) to the proper paper width so that the
tractor holes are aligned with the guide pins (3) on the front and rear guides.
Press down on the metal plate (6) (see Figure 57).
9. Lift the paper out of the tractors and push it up so that the trailing edge
aligns with the center of the splicing table tape slot. There should be some
slack in the forms (3) .
Note: This step cannot be performed if the hardware for printing tractorless
forms is installed. Instead, advance the paper and splice to the right of the
splicing table.
3
4