Table of Contents
Advertisement
12. Place the saturated pad in the plastic shipping bag and discard the bag in an
13. Install the new absorbent pad in the oil pan.
14. Reinstall the oil pan into the oiler-belt frame as follows:
3
1
15. Raise the hot roll shield.
16. Close the oiler-belt gate.
17. Turn the wing nut clockwise to latch the gate. Ensure that the gate is firmly
18. Close the stacker end cover.
19. The printer operator panel message may change to WARMING UP or PLEASE
20. To resume processing, select Start on the printer operator panel or the Main
approved waste container.
a. Insert the oil pan into the frame so that the clips at the bottom of the pan
(1) catch on the lower back support rod (2).
b. Lower the pan into position so that it sits securely inside the tabs (3) at the
lower edges of the oiler-belt frame.
latched.
STAND BY.
touch panel.
2
3
Chapter 7. Cleaning and Servicing the printer
1
317
Advertisement
Table of Contents
