Ricoh InfoPrint 4100 TS2 Operating Manual page 93

Table of Contents

6. Check the position of the form suspended between the tractors. If the middle

of the form is slack, the tractors are too close together.

7. Close the lower tractor covers.

8. When needed, lock the front and rear lower tractor latches by rotating the

latches (1) as shown.

9. Adjust the rear paper-edge guide as follows:

Note: This step applies to InfoPrint Models TS2 and TD3/4 when the Dual

Toner Mark/Side Verify Sensor feature (FC 4570) is installed.

Chapter 5. Working with forms