Table of Contents
Advertisement
Removing the PTFE mat and wear strip assembly
Before you begin
Printer 1 and Printer 2 must be powered off before you start this task.
About this task
Do this task when the PTFE mat or wear strip show obvious signs of wear or
damage, or you start getting offset on prints, or when the mat assembly is not
needed for the type of form you are running.
Procedure:
Procedure
1. Shut down and power off the system.
2. Remove all forms from Printer 2.
3. Open the center and top covers of the printer.
4. Open the back cover, the stacker gate and stacker door, and the oiler gate to
CAUTION:
<60>
High-temperature. Let parts cool at least 30 minutes in this area
before handling.
5. To remove the assembly:
!
CAUTION:
<2-24> Sharp edges exist in this area.
allow the air flow to help cool down the preheat platen.
a. Using both hands, grasp the lip (1) on the left end of the clip with your
left hand and grasp the right end of the clip (2) with your right hand.
Gently lift the clip from the shaft below the vacuum plate.
1
b. Rotate the clip out of the way (1) and slide the mat lifter tool under the
mat (2). Carefully lift the mat off the pins (3) and remove the entire
2
Appendix. Features
433
Advertisement
Table of Contents
