Table of Contents
Advertisement
A
10. Gently push each corona assembly back into place. Make sure that the corona
assembly is pushed in completely.
Note: The labels on the end of each corona assembly correspond to the labels
outside the drum. These indicate the correct location for each corona assembly.
When replacing corona wires, make sure that the correct corona assembly is
installed in the corresponding corona housing.
11. Close the right front cover of the printer by lifting the cover hinge bar and
sliding the bar toward the printer.
Important: The printer right front door must be completely closed whenever
the printer is running. Light entering the printer can significantly reduce print
quality.
12. Open the printer center front cover (1).
1
Chapter 7. Cleaning and Servicing the printer
337
Advertisement
Table of Contents
