Table of Contents
Advertisement
Procedure:
Procedure
9:56
6/28/11
Figure 63. Align Forms panel
164
Operating the InfoPrint 4100
v You cannot auto-align if you are using the UP
postprocessing interface.
v You must have the Side 2 Verify function enabled unless you are using
tractorless paper.
v Forms cannot be less than 3 inches in length.
v Auto-align of a duplex system cannot be done if the system is out of paper.
1. Select Forms → Align Forms.
2. Ensure that forms are properly threaded through Printer 1 and Printer 2.
3. Select Printer 1 Aligned on the Align Forms panel after you have visually
verified that the forms are aligned. This activates the Align Printer 2 function.
4. Select Align Printer 2.
a. Printer 1 prints a page with a dashed line (1). It also prints one or more
pages of arrows (2) on both sides of the line pointing towards it.
b. Printer 1 then prints a solid alignment mark on the alignment page. A
one-bar or two-bar pattern is also printed on the alignment page to show
whether Side 1 or Side 2 of the form is printed on Printer 1.
c. A fixed length of forms is fed through both Printer 1 and Printer 2. This
length is based on the "Printer 1 to Printer 2 Distance" configuration item
set in the Printer - Setup panel (Printer Definition → Printer → Setup ).
3
I intelligent pre- and
Advertisement
Table of Contents
