Table of Contents
Advertisement
Frequent
Tasks
Form Settings
Length
Special Marks
Width
Align Forms
Form Bar Code
Print
Registration
Tractorless
Advance
Paper (NPRO)
Oversize paper
Paper Weight
9:56
6/28/11
Start
Figure 46. Form Settings panel
2. If the name listed in the Form Name field contains the form definition you
3. If the name listed in the Form Name field does not contain the form definition
What to do next
If you are using the Auto Load sequence to load the forms, you must set the forms
length at the stacker control panel. See "Setting the forms length for Auto Load"
on page 134. If you are loading the forms manually, see "Loading forms using the
Forms Feed button" on page 82.
Loading forms using the Forms Feed button
Before you begin
Hold the tension arm so that it stays aligned with the blue mark on the guide
notch while you do the following steps. Otherwise, the 079A CHECK TENSION ARM
124
Operating the InfoPrint 4100
Forms
Maintenance
Units
11.0
mm
18.0
in
0
Tractorless (Tractored
Forms)
No
75 - 98 gsm (20 - 26 pounds)
Stop
Check/Reset
want to load, select Cancel.
you want to load, do the following:
a. Ensure that the length and width values are correct.
b. Select Frequent Tasks → Snapshots. You see a list of the currently defined
Snapshots.
c. If you are loading a Snapshot that has been previously defined, select the
Snapshot you want to load from the Saved Snapshots area, and select Load.
Note: If the Snapshot is not defined, see Chapter 4, "Working with Snapshots,"
on page 61 for more information about defining Snapshots.
Printer
Logon...
Definition
IPDS
Form Name
2UpLetter
Host Setup
0
Id
Commercial Print
Marks...
NO
Enable
OK
Advance
Paper (NPRO)
Shutdown
Cancel
Help...
Print
Registration
Advertisement
Table of Contents
