Ricoh InfoPrint 4100 TS2 Operating Manual page 197

b. The Front Sheet Sequence printer configuration value informs you which
side of the duplex form is printed on each printer in the system. This value
is set in the Printer - Basic panel (Printer Definition → Printer → Basic).
3. Select the arrows or type in numbers to change the print position. Values can
be entered in PELs, inches, or millimeters.
Note:
a. Remember that you are not moving the physical forms. You are moving the
image on the paper.
b. Be aware that the printed output can be rotated when it is printed.
c. The values vary depending on the printhead resolution (PEL) selected for
the printer. This value is set in the PDL - IPDS panel (Printer Definition →
Printer → PDL → IPDS).
4. To print a few pages of the current job with the current registration values, do
the following from the touch panel:
Note: This step and the remainder of the procedure can only be accomplished
if a queued print job is available.
a. Enter a value for X in Print X Pages, where X specifies the number of pages
you want to print.
b. Select Print. The printer uses the print registration values currently
displayed on the Print Registration panel.
Note: You must wait while the printer receives the job from the host.
c. Look at the pages just printed (located above the transfer station) to
determine how much to adjust the print position, if at all.
5. Select OK to return to the Main touch panel.
6. Select Start on the printer operator panel or on the Main touch panel to begin
printing.
Note:
a. After the printer has run for a few seconds, select Stop. Then look at the
output to ensure that the print position is still correct. Sometimes the print
position changes slightly when forms are moving at full speed.
b. Most applications generate a few sample pages at the beginning of each job
so that you can adjust the forms without losing any output. If you need
more sample pages to test, ask the host system console operator to restart
the job.
Chapter 5. Working with forms
183