Table of Contents
Advertisement
7. Ensure that the tension arm is aligned correctly. The mark on the tension arm
1
8. Turn on the forms path vacuum by pressing the Vacuum Push Button. The
9. Raise the tension arm until you see the alignment mark in the guide notch.
Checking alignment of tractored forms
About this task
Do this procedure to check that the forms are aligned correctly on the tractor holes.
Procedure:
Procedure
1. Check the tractor holes on the forms between the transfer station and the fuser
128
Operating the InfoPrint 4100
(1) should be visible in the notch in the transfer station frame.
Vacuum-Off warning indicator flashes and then stays off.
entry area. If the holes show signs of tearing, adjust the Tractor Control Knob
as needed.
Advertisement
Table of Contents
