2
3
330
Operating the InfoPrint 4100
d. Install the corona cartridge into the corresponding slot in the front wire
holder on the corona assembly as follows:
1) Tilt the cartridge (1) to position it so that the groove (4) slides under
the pin (5) on the front wire holder.
2) Push the cartridge down until the flexible latch on the cartridge (2)
snaps into place in the front wire holder (3).
1
4
e. Repeat the above steps to install a corona wire and cartridge into each slot
in the corona assembly.
f. Close the two corona wire covers (1) by pushing them in the E and F
directions.
5