Table of Contents
Advertisement
1. Mark Distance From the Top of Form specifies the placement of the mark in
2. Mark Width specifies the width of the mark. The default width is 0.13 inches.
3. Offset specifies the placement of the mark in the horizontal direction, relative
4. Page Number Location specifies the location of the side-verify page number
Note: Side verify marks are placed relative to the physical edge of the form to
allow printing the mark in the tractor strips on tractored forms. The marks are
printed in the same location on tractorless forms.
Registration Marks:
Figure 112 shows the adjustments you can make to the size and placement of
special registration marks. Registration marks can be printed on Printer 1, Printer
2, both printers, or not printed.
1
2
4
3
Figure 112. Size and placement of registration marks
1. Alignment value set to Towards Back of Printer positions the mark at the back
2. Alignment value set to Centered positions the mark in the center of the form
362
Operating the InfoPrint 4100
the vertical direction, relative to the top of the form (the distance from the top
edge of the form to the top edge of the mark).
(This field is available to service personnel only.)
to the front (outside) edge of the form. The default position is 0.01 inches from
the front edge of the form.
(before or after the side verify mark). This prints the same number on the front
and back side of the page for use in page verification. The page number can be
specified for either or both printers.
Back of Printer
5
6
7
Page Length
Front of Printer
edge of the form (the back edge of the mark is aligned with the back edge of
the form). Use the Offset field to adjust the alignment from this starting
position.
(the center of the mark is aligned with the center of the form). Use the Offset
field to adjust the alignment from this starting position.
Paper Feed Direction
Advertisement
Table of Contents
