Table of Contents
Advertisement
Figure 96. Universal Forms Control Sensors
4. Cleaning the toner mark/side verify sensor (if installed): Clean the area under
266
Operating the InfoPrint 4100
1
the toner mark/side verify sensor (2) as follows:
a. Loosen the thumbscrew (1).
b. Flip the sensor up so that you can access the area under the sensor.
c. Use a toner-certified vacuum cleaner to clean the bottom of the sensor and
the surrounding area (3).
d. Flip the sensor back into place.
e. Tighten the thumbscrew.
2
3
Advertisement
Table of Contents
