Table of Contents
Advertisement
v DHCP Plug-and-Play
v Internet Name of Local Host
v IP Address of Primary DNS Server
v IP Address of Secondary DNS Server
Media Speed
For proper operation, the Media Speed setting of the adapter must match
the Media Speed setting of the switch port that is connected to the printer.
For example, if the printer is set to 100 Full Duplex, then the switch port
must also be set to 100 Full Duplex. If the printer is set to Auto
Negotiation, then the switch port must also be set to Auto Negotiation.
Contact your network administrator for more information about switch
port settings.
DHCP Time Out
Some switches perform a Spanning Tree loop check whenever a link is
established on a switch port. The check may take several seconds, or even
minutes. During this time, the switch does not pass network packets from
the printer. This can result in the inability to obtain information from a
DHCP server. If this occurs, you may be able to avoid the problem by
increasing the DHCP Time out value.
If DHCP Addressing is On, the following values are obtained from the DHCP
server and therefore cannot be set on the printer console panels:
v IP Address
v Subnet Mask
v Default Gateway
v Domain Name of Local Host
If DHCP Plug-and-Play is Enabled (primary only), the following values are
requested from the DHCP server and therefore cannot be set on the printer console
panels:
v IP Address of Primary DNS Server
v IP Address of Secondary DNS Server
v SMTP Mail Server Address (Printer Definition → Network → Remote Access →
E-mail → Edit)
v Specific time server IP Address (Printer Definition → Printer → Date/Time →
Time Source → Specific Network Server → Time Server Name)
v Specific time server type (Printer Definition → Printer → Date/Time → Time
Source → Specific Network Server → Time Server Type)
Note: To see help information for the fields on this panel, select the field and press
F1 on the keyboard or press and hold the left mouse button for two seconds. A
help popup window displays detailed information about the selected field. Select
the Help button to display a help topic for the panel. The help topic displays in a
separate Help window inside a Help System viewer. Select the Alt+Tab key to
toggle between the Help window and the operator console. Select the Alt+F4 key
to close the Help window.
Administrator panel
Chapter 8. Help topics for the InfoPrint 4100 operator console
383
Advertisement
Table of Contents
