Ricoh InfoPrint 4100 TS2 Operating Manual page 129

7. Ensure that the tension arm is aligned correctly. The mark on the tension arm
(1) should be visible in the notch in the transfer station frame.
1
8. Turn on the forms path vacuum by pressing the Vacuum Push Button. The
Vacuum-Off warning indicator flashes and then stays off.
9. Raise the tension arm until you see the alignment mark in the guide notch.
Starting the printer
About this task
Do this procedure to start the printer from the touch panel or the printer control
panel.
Procedure:
Procedure
Press the Start key on the operator panel or select Start on the Main touch panel
for the affected printer.
v If the forms now loaded in the printer are different from the forms that were
used last, see "Checking print quality" on page 190.
v If preprinted forms are now loaded in the printer and you want to check or
adjust the registration, see "Setting print registration" on page 129.
v If you are loading both printers in a Duplex system, you will need to load
Printer 1 and align the forms on Printer 1, then load Printer 2 and align the
forms on Printer 2. Depending on the type of form you are loading, refer to
"Aligning tractored forms" on page 155 or "Aligning tractorless forms" on page
163.
Chapter 5. Working with forms
115