v Ensure that the box does not block any sensors in the forms input area. If
you see the red light of the sensor reflecting on the box, take the forms out
of the box, or cut down the sides of the box so that it is no longer blocking
the sensors.
Generally, it is best to take the forms out of the box near the printer, and then
slide them into position in the forms input area. Leaving forms in the box can
also cause excess tension on the forms. This can cause tractor jams.
3. Position the form stack so that the forms do not twist or tear when they travel
around the input guide and the splicing table.
Note: Only
Chapter 5. Working with forms
89