Table of Contents
Advertisement
17. Ensure that the forms are aligned squarely on the tape slot and secure them
18. Press firmly on the forms and tape along the tape slot. Ensure that the print
19. Move the Splice Lever to the "Run" position to turn off the splicing table
20. Take up the slack in the paper web and align the forms on the tractor feed
21. Press the blue button (4) to release the web support guide so that it covers the
1
2
Figure 59. Splicing table
22. Close the tractor covers.
23. Lift the paper off the rear guide pins and move the rear paper-edge guide
24. Close the center front and center top covers of the printer.
25. Select Start on the printer operator panel or on the Main touch panel for the
154
Operating the InfoPrint 4100
using the splicing tape.
Note: Splicing tape tends to lose its adhesive quality when it is touched.
Avoid touching the adhesive with your hands. Also, keep tape away from the
forms until you are ready to actually tape them.
surfaces of both forms are securely attached to the splicing tape.
vacuum.
pins.
guide pins at the front of the splicing station.
5
6
Ensure that the new forms are correctly loaded. They should pass from the
input area and over the forms guides on the left side of the splicing table.
with the toner mark/side verify sensor to the run position. See "Adjusting the
rear paper-edge guide and Dual Toner Mark/Side Verify Sensor" on page 146.
affected printer.
3
4
Advertisement
Table of Contents
