Table of Contents
Advertisement
Procedure
1. If you are not using Snapshots, and you want to change the currently loaded
Frequent
Tasks
Form Settings
Length
Special Marks
Width
Align Forms
Form Bar Code
Print
Registration
Tractorless
Advance
Paper (NPRO)
Oversize paper
Paper Weight
9:56
6/28/11
Start
Figure 55. Form Settings panel
2. If you are using Snapshots and the form settings you want to use are already
form, do the following:
a. Select Forms → Forms Settings to display the Form Settings panel.
b. Change the values in Width, Length, Form Name, as needed.
c. Select OK to save the current form settings.
Forms
Maintenance
Units
11.0
mm
18.0
in
0
Tractorless (Tractored
Forms)
No
75 - 98 gsm (20 - 26 pounds)
Stop
Check/Reset
contained in a Snapshot, do the following:
a. Select Frequent Tasks → Snapshots. You see a list of the currently defined
Snapshots.
b. Select the Snapshot that contains the form settings you want to load.
c. Select Load.
d. Select OK.
Note: If you are using Snapshots but the form settings you want to use are not
currently contained in a Snapshot, refer to "Creating Snapshots" on page 65 for
information about saving the form settings you created in Step 1 into a new
Snapshot.
Printer
Logon...
Definition
IPDS
Form Name
2UpLetter
Host Setup
0
Id
Commercial Print
Marks...
NO
Enable
OK
Advance
Paper (NPRO)
Shutdown
Cancel
Help...
Print
Registration
Chapter 5. Working with forms
145
Advertisement
Table of Contents
