Table of Contents
Advertisement
Puller Run button (7)
Stack Height Adjustment (3)
HEIGHT
STACK
(mm)
(inch)
9
250
10
11
12
300
13
14
350
15
16
400
Paper Dust Collector Box (8)
Lift Pin Lever (9)
Table 4. Lift Pin Lever (9) Positions
Printer
Printer 1 duplex - 9pt
Printer 1 duplex - not 9pt
Printer 1 dual simplex (both)
1
1
2
3
Recommended Position
3mm (position 2)
3mm (position 2)
3mm (position 2)
Applies pressure to the scuff and backup rollers inside
the fuser area when setting the tension arm position.
Turns the puller rolls on for five seconds.
Note: The Stack Height Adjustment gauge is only
available if a stacker is installed.
Collects the paper dust created during operation. To
empty the Paper Dust Collector Box:
1. Remove the two screws (1) on the cover plate.
2. Remove the box.
3. Dispose of the paper dust in the box.
4. Reinstall the box.
5. Reinstall the two screws.
Enables the printer to use Enhanced Commercial Print
(9pt) media. To set the printer engine(s) for Enhanced
Commercial Print see Table 4.
Chapter 1. Introducing the printer
Other Possible Positions
0mm (position 3)
0mm (position 3)
0mm (position 3)
21
Advertisement
Table of Contents
