Table of Contents
Advertisement
Note: The thumbscrew (4) adjusts the position of the Dual Toner
Mark/Side Verify Sensor on the bottom side of the sensor mounting plate.
It must be turned fully counterclockwise to position the sensor to read the
side verify or registration marks at the outside edge of the paper (this is
the default position). If you change the location of the marks (Forms →
Special Marks), you must adjust the position of the sensor. See "Adjusting
the rear paper-edge guide and Dual Toner Mark/Side Verify Sensor" on
page 146 for more information.
What to do next
For tractored forms, check that the forms are aligned correctly on the tractor holes.
See "Checking alignment of tractored forms" on page 128. For tractorless forms,
start the printer. See "Starting the printer" on page 133.
Changing forms settings on Printer 1
Before you begin
Do this procedure to select and load the correct Snapshot when you are changing
to a different size form on Printer 1.
Note: Do this step when loading forms in Dual Simplex mode or loading Printer 1
in Duplex mode.
About this task
Procedure:
Procedure
1. Select Forms → Form Settings to display the Form Settings panel.
Chapter 5. Working with forms
123
Advertisement
Table of Contents
