Table of Contents
Advertisement
You can save your changes using a new Snapshot name so that the original
Snapshot can still be used. Alternatively, you can save your changes into the
currently loaded Snapshot, so that your changes overwrite the original settings.
Note: Remember that the InfoPrint default Snapshots may be modified and used
with the current print job, but if you want to keep those changes, you must save
them to a new Snapshot.
Users with Administrative access authority can view and change values in multiple
Snapshots. Refer to the Planning and Configuration Guide for more information.
Procedure:
Do this procedure to make changes to the currently loaded Snapshot and then save
those changes.
Procedure
1. Select the Snapshots panel (Frequent Tasks → Snapshots) on the touch panel.
2. Before saving any changes to a Snapshot, make sure that all the printer and
3. Navigate back to the Snapshots panel (Frequent Tasks → Snapshots).
4. Before saving the changed Snapshot, select Show Details... to display the
5. Select Save current settings as.... You will be prompted to enter a name for the
6. Select OK.
7. Select Close to return to the Main panel.
66
Operating the InfoPrint 4100
forms values are set correctly.
a. Select the Snapshot you want to change from the list of Saved Snapshots.
b. Select Load to load the settings for the selected Snapshot. The selected
Snapshot is now the currently loaded Snapshot and its name is displayed in
the Snapshot Loaded field.
c. Review the Snapshot settings in the right pane.
d. Select Show Details... to display all settings in a separate window. Select
OK to close that window.
e. If you want to change any of the settings, navigate to the appropriate touch
panel where the value is set, make the change, and select OK to save those
changes. Any changes you make will be applied to the Snapshot that is
currently loaded when you save the Snapshot.
Note: Refer to table of snapshot values (Table 10 on page 61) for a list of
values that are saved in Snapshots and where those values are defined on
the console touch panels.
settings for the printer and forms values in the right pane. Verify that the
changes are shown.
Snapshot you are saving. If this is a new Snapshot, the name field will be blank
and you can type in the new Snapshot name. If this is not a new Snapshot, the
name field will be filled in with the name of the loaded Snapshot. You can save
it with that name or specify a new name. If you save it with the same name,
your changes will overwrite the original Snapshot with that name.
Advertisement
Table of Contents
