Table of Contents
Advertisement
5
1
Figure 82. Forms alignment
2. If the forms perforation (1) is not aligned correctly, do the following:
Auto Load
Forms Set
Load
STOP
Figure 83. Forms Set indicator on the printer control panel
3. If you are using the stacker, ensure that the Forms Set indicator on the printer
4. If you are doing this procedure as a step in an intervention procedure, continue
4
5
2
3
a. Hold the tension arm so that it stays aligned with the blue mark on the
guide notch while you do the following steps. Otherwise, the 079A CHECK
TENSION ARM 079A message appears when you turn on the forms path
vacuum, and you must do the Check Tension Arm procedure.
b. Turn off the forms path vacuum by pressing the Vacuum Push Button in
the input area of the affected printer. The Vacuum-Off Warning indicator
flashes and then stays lit.
c. Use the Forms Feed keys (3) on the printer control panel to adjust the
position of the perforation.
d. Turn on the forms path vacuum by pressing the Vacuum Push Button. The
Vacuum-Off Warning indicator flashes and then stays off.
e. Raise the tension arm until you see the alignment mark in the guide notch
(see "Checking the tension arm" on page 147.
Toner
Mark
Forms Feed
Forward
Reverse
control panel is set to match the fold direction of the fold perforation on the
lower transfer station tractors.
with the steps in that procedure.
Chapter 5. Working with forms
189
Advertisement
Table of Contents
