Table of Contents
Advertisement
10. If you are using tractorless forms, engage the tractorless pressure roller (6).
11. If you are using tractored forms, disengage the tractorless pressure roller (6).
12. Ensure that the forms are aligned correctly and the printer is adjusted
Loading the correct forms settings
About this task
Do this procedure to load the correct forms settings after you have adjusted the
printers. Forms settings are specified using the Form Settings panel. Form settings
are also contained in a Snapshot, so if you prefer, you can load a Snapshot that
contains the settings in just one step.
Procedure:
144
Operating the InfoPrint 4100
c. Tighten the thumbscrew (2).
Note: The thumbscrew (4) adjusts the position of the sensor on the bottom
side of the sensor mounting plate. It must be turned fully counterclockwise
to position the sensor to read the registration mark at the outside edge of
the paper (this is the default position). If you change the location of the
registration mark (Forms → Special Marks), you must adjust the position of
the sensor.
9. See "Adjusting the rear paper-edge guide and Dual Toner Mark/Side Verify
Sensor" on page 146 for more information.
properly.
Advertisement
Table of Contents
