Table of Contents
Advertisement
6. Bring the forms up from the input area, over the forms guide(s), under the
static brush, and across the splicing table.
7. If you are loading a form with a different width, use the Tractor Control
Knob to adjust the tractors close to the correct width. Use the scale just to the
left of the tractor covers.
8. Without putting the forms on the tractor pins if you are using tractored forms,
carefully thread the forms:
a. Over the transfer station lower tractors
b. Around the retractors
c. Under the small, plastic paper guides to the right of the upper tractors
d. Over the upper tractors
9. If necessary, use the Tractor Control Knob to adjust the distance between the
front and rear tractors:
v To increase the distance, turn the Tractor Control Knob clockwise.
v To decrease the distance, turn the Tractor Control Knob counterclockwise.
When the tractors are adjusted correctly, a sheet of forms should drop easily
onto the tractor pins and lay flat if you are using tractored forms. The pins
should be centered in the tractor holes, without binding.
10. Place the forms to the right of the transfer station jam sensor.
Note: Do not cover the jam sensor with the forms.
Chapter 5. Working with forms
121
Advertisement
Table of Contents
